TM 5-5675-319-14
NOTE
• Exposure light glows during exposure and is extinguished when exposure is
complete.
• W h e n m u l t i p l e - p r i n t p r o c e s s i s c o m p l e t e , p r i n t e r a u t o m a t i c a l l y s t o p s . I f
multiple copies of other negatives are required, repeat step for type
of negative being copied and step (39), (a) through (e).
(f) When multiple-print operation is complete, turn off LIFTER POWER
switch .
(g) Set APL single/multiple print switch to SINGLE .
NOTE
The APL must be turned off at bottom of its stroke or printer will not
operate in manual or automatic mode.
(h) Turn off TRANSPORT POWER switch.
(i) Remove exposed printing material from roll and process.
(j) Remove negative roll from printer and store.
(l) When roll-paper printing operation is complete, proceed to step
(41) for printer securing operations .
( 4 0 ) P r i n t c u t - s h e e t m a t e r i a l a s f o l l o w s:
(a) Place cut-sheet to be printed (emulsion side down) over mask cutout
on print stage.
NOTE
When cut-sheet printing material is used, white border is obtained by
placing printing material over mask.
If black border is desired, place
printing material under mask.
(b) Lower and lock printer hood.
NOTE
Exposure light glows during exposure and is extinguished when exposure is
complete.
9-49
