TM 5-6675-319-14
( 3 2 ) T h r e a d r o l l - p a p e r p r i n t i n g m a t e r i a l o n p r i n t e r a s f o l l o w s :
(a) Install empty spool on holder at right side of RPT.
( b ) I n s t a l l r o l l - p a p e r p r i n t i n g m a t e r i a l o n h o l d e r a t l e f t s i d e o f
RPT.
(c) Thread printing material (emulsion side down) as shown in threading
diagram.
(33) Check that APL single/multiple print switch is on SINGLE.
(34) Turn on TRANSPORT POWER switch.
(35) Check for proper paper advance spacing as follows:
(a) Loosen thumbscrew and slide marker assembly from hood.
(b) Reinstall assembly with graphite wheel down.
(c) Aline graphite wheel with marker table at printer stage.
(d) Set RPT revolution counter to proper number, which is approximately
96 for 10 in. (25.4 cm) wide original with 3/4 in. (19.05 mm) spacing between prints.
(e) Mark paper by lowering hood without locking platen handle. The n
raise hood.
NOTE
When hood is lowered, marker assembly will place mark on printing material.
(f) After paper advances, again lower hood without locking platen
handle and mark paper.
(g) Measure distance between two marks and adjust paper advance
a c c o r d i n g l y.
(h) Reverse marker assembly.
NOTE
•
If
single
copy
of
negative
is
required,
follow
steps
(36)
through
(38).
•
If
multiple
copies
of
negative
are
required,
proceed
to
step
(39).
(36) Lower and lock hood, and expose printing material.
9-47
