NOTE
Exposure light glows during exposure and is extinguished when exposure
is complete.
(f) When multiple-print process is complete, unlock and open printer
hood.
( g ) I f m u l t i p l e c o p i e s o f o t h e r n e g a t i v e s a r e r e q u i r e d , p o s i t i o n n e xt
negative on print stage and repeat step (35), (a) through (f).
(h) When multiple-print operation is complete, set LIFTER POWER switch
to OFF.
( i ) S e t A P L s i n g l e / m u l t i p l e p r i n t s w i t c h t o S I N G L E.
NOTE
The APL must be turned off at bottom of its stroke or printer will not
operate in manual or automatic mode.
(j) Turn off TRANSPORT POWER switch.
(k) Remove exposed printing material from roll and process.
( l ) R e m o v e r o l l p r i n t i n g m a t e r i a l f r o m p r i n t e r a n d s t o r e .
(m) When roll-paper printing operation is complete, proceed to step (j)
f o r p r i n t e r s e c u r i n g o p e r a t i o n s.
( 3 6 ) P r i n t c u t - s h e e t m a t e r i a l a s f o l l o w s:
(a) Place cut sheet to be printed (emulsion side down) over negative.
NOTE
When cut-sheet printing material is used, white border is obtained by
placing printing material over mask.
I f b l a c k b o r d e r i s r e q u i r e d , p l a c e
printing material under mask.
(b) Lower and lock printer hood.
NOTE
Exposure light glows during exposure and is extinguished when exposure is
complete.
TM 5-6675-319-14
9-40
