TM 5-6675-319-14
e .
Remove screw, lockwasher, washer, and bearing from upper roller shaft on
d r i v e s i d e p l a t e.
f. Remove screw and bearing guide and then remove drive side plate.
g .
Remove screw, lockwasher, washer, and bearing from upper roller shaft on
i d l e s i d e p l a t e.
h. Remove nuts and tie rods on idle side plate .
NOTE
Tie rod retaining nuts on idle side are shorter than nuts on drive side.
i .
Remove screw and bearing guide from idle side plate.
j .
Remove screw, lockwasher, washer, bearing from lower roller and then
remove idle side plate.
k. Crossover is now completely disassembled. Inspect all parts for damage
or wear.
Replace defective components as necessary.
l .
R e i n s t a l l l o w e r r o l l e r o n i d l e s i d e p l a t e a n d r e i n s t a l l b e a r i n g , w a s h e r,
lockwasher, and secure with screw.
m.
Reinstall upper roller on idle side plate and reinstall bearing, washer,
lockwasher and secure with screw.
Be sure flat surface of bearing faces
bearing guide.
n.
Reinstall bearing guide and secure with screw on idle side plate.
o.
Reinstall tie rods on idle side plate and secure with short nuts.
P.
R e i n s t a l l d r i v e s i d e p l a t e a n d p o s i t i o n r o l l e r s , t i e r o d s , a n d f i lm
guide shoe in appropriate hole. Secure tie rods with two nuts.
NOTE
Be sure that washer installed in next step is the Identification washer
r e m o v e d i n s t e p e . , a n d i s i n s t a l l e d w i t h i d e n t i f i c a t i o n l e t t e r o u t .
q .
Reinstall bearing on upper roller and secure with washer, lockwasher, and
screw.
Be sure flat side of bearing faces bearing guide .
r .
Reinstall bearing guide and secure with screw.
s.
Reinstall bearing, sleeve, gear with woodruff key on lower roller and
secure with washer, lockwasher, and screw.
t .
Reinstall remaining film guide shoe and secure with screws.
u.
R e i n s t a l l c r o s s o v e r a s s e m b l y i n p r o c e s s o r.
2-137
