TM 5-6675-319-14
NOTE
The following procedure is in a disassembly/assembly sequence. Disassemble
the pump assembly only as far as necessary to perform the repair.
b.
c .
d.
e .
f .
g .
h.
i .
NOTE
Note position of pump housing before disassembly.
Remove wing nuts, and remove right and left pump housings.
Remove and discard O-rings.
Remove screws and impeller assemblies.
Remove capacitor from motor.
I n s t a l l n e w c a p a c i t o r .
Reinstall new impeller assemblies and new O-rings on motor assembly.
Reinstall left and right pump housings, and secure with wing nuts. Make
sure that pump housings are properly positioned.
Replace pump motor assembly in processor (paragraph 2-20.12 steps i.
through k).
a. Remove pump from processor (paragraph 2-16.12 steps a. through h).
2-141
