TM 5-6675-318-14
(o) Using dynamometer, push cable at midpoint until it just
Pull cable at loop crimp terminal
touches rear track edge.
until cable tension of about 300 grams is obtained on gage.
S e c u r e l y crimp loop crimp terminal to cable and cut off excess
cable.
(14) Adjust cable tension for 325 + 25 g. Refer to cable tension
adjustment procedure (paragraph 3-29.3).
(15) Lower upper deck assembly and reinstall rear hood.
3-29.18 HP-IB Logic Board Replacement.
MOS:
35E, Special Electronic Devices Repairer
T O O L S : Cross Tip Screwdriver (No. 1)
SUPPLIES:
PCA Assembly
a.
On side of PCA enclosure with dimple, remove two screws shown.
b.
Turn PCA enclosure over and remove four screws shown.
c.
Grasp both sides of PCA enclosure and carefully pull them apart.
3-306
