TM 5-6675-316-14
NOTE
Through motor access hole, push motor assembly to right and hold until
carriage is approximately in center of X-rail, then release.
ef.
Set X-carriage at end of X-rail with end plate removed. ,
eg.
Hold limit switch cams clear of trip dog.
eh.
Carefully move X-carriage past trip dog to approximately center of
X-rail.
ei.
Install tensioning device.
ej.
Mount fine adjustment device on X-rail.
ek.
Raise arrest stop pin.
el.
Slide device into arrest.
em.
Lower stop pin into hole in shaft of device.
en.
Adjust X-carriage bearing screws to allow X-carriage to move easily,
and with no restrictions.
eo.
Move X-carriage to mid-position of X-rail.
ep.
Remove socket head capscrews from X-carriage cover.
eq.
Remove cover.
er.
Connect five ribbon cables to cable connector on X-carriage.
e s .
Tighten cable connectors.
et.
Reinstall cover.
3-199
