TM 5-6675-315-14
s.
Close relay box cover.
t.
Reinstall feed table and close front cover.
u.
Roll machine to rear end of van and remove machine from van.
v.
Position new machine at proper location.
w.
Open front cover.
x.
Remove feed table.
y.
Open relay box cover.
z.
Run power cable under machine and up to main power cable insert hole in relay box.
aa.
Run wires through relay box power cable hole and reinstall nut on fitting tightly.
ab.
Remove tape on wires and hook up wires to terminals indicated by tags on each wire.
NOTE
Be sure all connections are tight and no bare wires are showing.
ac.
Close relay box.
ad.
Reinstall feed table and close front cover.
ae.
Move machine over shock mounts.
af.
Aline mounting holes on machine over bolt holes on air shocks.
ag.
Insert spacer plates over air shocks.
CAUTION
When inserting mounting bolts, be sure bolts are not cross threaded.
ah.
Insert mounting bolts on all four corners into air shocks and tighten.
ai.
Raise rollers on all four corners.
aj.
Tighten all mounting bolts.
al.
Inflate air shocks if preparing for transport mode.
2-131
