TM 5-6675-315-14
2-20. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering direct/general support maintenance functions for the shredder-
bagger. Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is
properly functioning.
INDEX
PROCEDURES
PARAGRAPH
Replace Conveyor Belt ...............................................................................................................................
2-20.1
Repair Cutter Assembly ..............................................................................................................................
2-20.2
Replace Cutter Drive Motor.........................................................................................................................
2-20.3
Replace Solenoid Valve ..............................................................................................................................
2-20.4
Replace Pressure-Activated Switch.............................................................................................................
2-20.5
Replace Pump Motor Assembly ..................................................................................................................
2-20.6
2-20.1
Replace Conveyor Belt.
MOS:
83FJ6, Reproduction Equipment Repairer
TOOLS:
Flat Tip Screwdriver
No. 2 Cross Tip Screwdriver
5 mm Hex Head Key Wrench
6 in. Adjustable Wrench
22 mm Combination Wrench
SUPPLIES:
Conveyor Belt
WARNING
Death or serious injury can occur from electrical shock unless power is turned off before servicing.
a.
Turn off circuit breaker.
b.
Turn off main power switch.
c.
Move shredder-bagger away from wall (paragraph 2-16.21).
2-136
