TM 5-6675-315-14
j.
Loosen screws holding trip dog A in place.
·
NOTE
·
The position and length of trip dogs determine timing of control system operation. A trip
dog out of position could adversely affect operation of machine.
Initial measurement for positioning of trip dog A should be made from ram.
k.
Slide trip dog A until front of trip dog A is 13.75 in. (34.9 cm) from ram mounting plate. Tighten screws.
l.
Turn circuit breaker on.
m.
Turn on main power switch.
WARNING
Death or serious injury may occur from electrical shock unless power is off before adjusting.
n.
Cycle ram until trip dogs B, C, and D are accessible. Then turn off power.
o.
Loosen screws on trip dog B. Slide trip dog B until the front of the trip dog is 18.25 in. (46.3 cm) from the rear of
trip dog A. Tighten screws.
p.
Loosen screws which secure both trip dog C and trip dog D. Slide trip dog C until the front of the trip dog is 17.25
in.(43.8 cm) from the rear of trip dog A. Slide trip dog D until the front of the trip dog is 17 in. (43.1 cm) from the
rear of trip dog A. Tighten screws.
q.
Reinstall control switch rail cover plate, bottom front panel and bottom side panel.
r.
Turn power on and press rear safety switch. Press ram reverse switch until ram is at its fully retracted position.
2-83
