TM 5-6675-315-14
i.
Remove torsion damper screw bracket and screws holding centrifugal switch in place.
j.
Turn drum axle of roller 90 degrees. Remove centrifugal switch, drive drum, and washers.
k.
Reinstall drive drum. Place sufficient washers between drum and centrifugal switch to prevent belts from rubbing
against switch.
NOTE
Shaft takes 6 mm (0.31 in.) ID washers.
l.
Reinstall centrifugal switch FL on drum axle.
m.
Turn drum axle back 90 degrees.
n.
Reinstall torsion damper screw bracket and switch holding screws.
2-78
