TM 5-6675-315-14
NOTE
Top of cutter mechanism side panel hangs from pair of brackets.
f.
Loosen two screws on rotor vane shaft mounting bracket. Turn bracket left until bracket is clear of screws.
g.
Grasp red knob and draw shaft out.
h.
Adjust hex nut on shaft approximately one-tenth turn.
NOTE
Rotor vane is driven by safety clutch. It is properly adjusted when shaft can still be turned by
hand when shredder-bagger is off.
i.
Push shaft in and turn mounting bracket right. Do not tighten screws.
j.
Test adjustment by trying to turn shaft with knob by hand. If shaft cannot be turned or it slips, repeat steps f.
through h. until shaft can just barely be turned by hand. Tighten mounting bracket screws.
k.
Reinstall cover panel.
l.
Turn on circuit breaker.
m.
Turn on main power switch.
2-85
