TM 5-3610-287-24
3-16. REPAIR PERSONNEL/EQUIPMENT DOOR (CONT)
WARNING
CHEMICAL HAZARD. Use adhesive in a well-ventilated area.
Adhesive is harmful to eyes and skin. In case of contact
with eyes, immediately flush eyes with water for 15 minutes,
then seek medical help. In case of contact with skin, wipe
off with dry cloth, then wash with soap and water.
7.
Apply adhesive to area where new seal (3) is to be placed.
Press new seal (3) onto door (1).
Wipe off excess adhesive.
8.
9.
Install screw nails (2) to new seal (3).
10.
Apply adhesive to area inside and outside where new corner tab seals
(5) are to be placed. Press corner tab seals (5) into place. Wipe
off excess adhesive.
Apply adhesive to area where new corner reinforcement seals (4) are to
11.
be placed. Press new corner reinforcement seals (4) into place. Wipe
off excess adhesive.
NOTE
The following step applies to equipment door only.
12.
On curbside edge of equipment door, cut outer flap of seal flush with
door.
Close door (1) and check for proper seal.
13.
Expanding side assembly is repaired by replacing:
a. Wiper seal
b. Rubber strip seal c. Seal
WIPER SEAL
INITIAL SETUP
Tools
Master mechanic's tool kit (appendix B, section III, item 18)
Flat-tip screwdriver
Folding ladder
3-22
