TM 5-3610-287-24
REPAIR EXPANDING SIDE ASSEMBLY (CONT)
3-17.
1.
Remove removable floor sections.
2.
Remove hex bolts (1) and vertical and horizontal inner metal
strips (2).
Starting at bottom end, remove rubber strip seal (3) from track (4).
3.
CAUTION
Do not cut excess length from rubber strip seal. Excess
length will be drawn into track after seal is inserted.
Cutting seal may cause expanding side to leak.
4.
Place upper right and left molded corners of new rubber strip seal
(3) in track (4).
Starting at center of upper track (4), insert rubber strip seal (3),
5.
moving toward upper molded corners.
Starting at center of vertical tracks (4), insert rubber strip seal
6.
(3), moving toward upper molded corner and bottom of track.
7.
Position metal strip (2) and install hex bolts (1).
8.
Install removable floor sections.
INITIAL SETUP
Tools
Master mechanic's tool kit (appendix B, section III, item 18)
Flat-tip screwdriver
Materials/Parts
Seal, 54-0199-53 (2 required)
Seal, 54-0195-105
Equipment Conditions
Section level and expanded (TM 5-3610-287-10, para 2-6)
3-25
