TM 5-3610-287-24
REPLACE PERSONNEL/EQUIPMENT DOOR (CONT)
3-15.
5.
Tighten hex nuts (9) attaching hinges to Section body.
Test operate door (4) for proper operation.
6.
Check for binding or
misalignment.
7.
Position cover plates (2) and install screws (1).
NOTE
The following step applies to equipment door only.
Install bulletin board, blackout curtain tiedowns, and strap and
8.
buckle assembly.
NOTE
The following steps apply to rear personnel door and
equipment door only.
9.
Install boarding ladder on outer boarding ladder mounting
bracket (10).
10.
To locate and mark mounting holes, install inner boarding ladder
mounting bracket (7) on mounted boarding ladder and position on door.
Locate and mark mounting holes for mounting bracket (7).
11.
12.
Remove boarding ladder and mounting bracket (7) from door.
Drill mounting holes and tap holes for bolts (6).
13.
WARNING
CHEMICAL HAZARD. Use silicone compound in a well-ventilated
area. Silicone compound is harmful to eyes and skin. In
case of contact with eyes, immediately flush eyes with water
for 15 minutes, then seek medical help. In case of contact
with skin, wipe off with dry cloth, then wash with soap and
water.
Apply silicone compound to back of inner boarding ladder mounting
14.
bracket (7) and install on door with bolts (6) and lockwashers.
Install boarding ladder on mounting brackets. Adjust mounting
15.
brackets on boarding ladder as necessary.
Remove boarding ladder from mounting brackets (7) and install for
16.
operation.
3-19
