TM 5-3610-287-24
2-50.
REPAIR POWER MONITOR ASSEMBLY (CONT)
4.
Remove nuts (5), screws (6), and frequency meter (7).
5.
Install new frequency meter (7) with screws (6) and nuts (5).
6.
Install wires (3), flatwashers, and hex nuts (4).
7.
Install power monitor assembly (2) with hex bolts (1), lockwashers,
and flatwashers.
WARNING
ELECTRICAL HAZARD. Do not connect power cable to Section
before grounding. Failure to observe this warning may
result in death or serious injury.
8.
Ground Section and connect main power cable.
9.
Test operate by checking for correct phase and voltage (TM 5-3610-
287-10, para 2-6).
10.
Set MAIN POWER switch to ON.
CIRCUIT CARD ASSEMBLY
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Cross-tip screwdriver
Flat-tip screwdriver
Socket wrench set
Soldering iron
Extension light
Materials/Parts
Circuit card assembly, 13225E3282
Masking tape (appendix C, item 29)
Lead pencil (appendix C, item 13)
2-153
