TM 5-3610-287-24
2-50. REPAIR POWER MONITOR ASSEMBLY (CONT)
WARNING
ELECTRICAL HAZARD. Main power cable MUST be disconnected
from Section before performing maintenance on power monitor
assembly. Wiring to power monitor assembly comes directly
from main power input receptacle. Failure to disconnect
main power cable WILL result in death or serious injury.
1.
Set MAIN POWER switch to OFF and disconnect main power cable.
2.
Remove hex bolts (1), lockwashers, and flatwashers.
Rest power
monitor assembly (2) on load center.
Remove screws (3) and lockwashers, and partially remove circuit card
3.
assembly (4).
4.
Remove screws (5), lockwashers, and standoffs (6).
Tag and remove wires (7) and circuit card assembly (4).
5.
2-154
