TM 5-3610-287-24
2-21.
REPAIR EMERGENCY LIGHT SET (CONT)
WARNING
Unplug emergency light power cord before
ELECTRICAL HAZARD.
Failure to do so may result in death or
replacing battery.
serious injury.
1.
Turn off emergency light and unplug power cord.
2.
Remove two screws (1) securing emergency light cover (2) to emergency
light set (3).
3.
Remove positive (red) and negative (black) wires (4) from battery
posts.
4.
Tilt top of battery (5) out and remove from emergency light set (3).
5.
Install new battery (5) in emergency light set (3).
6.
Connect positive (red) wire and negative (black) wire (4) to battery
posts, observing polarity.
7.
Install emergency light cover (2) with screws (l).
8.
Plug in emergency light power cord and set toggle switch to ON.
9.
Push TEST button (6) down to test battery operation.
PRINTED CIRCUIT BOARD
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Cross-tip screwdriver
Flat-tip screwdriver
Pliers
Soldering iron
Materials/Parts
Printed circuit board, GSA78
Masking tape (appendix C, item 29)
Lead pencil (appendix C, item 13)
2-57
