TM 5-3610-286-20
2-50.
Pull Rail Assembly (cont).
c. Install. (figure 2-111)
NOTE
Steps (1) and (2) are for only one of the pull
(1) Install shims (1), compression spring (2), and bolt (3).
(2) Install support (4), washer (5), and socket-head screw (6).
rail assemblies,
(3) Install two guide pieces (7) and eight socket-head screws (8).
(4) Install feed table (9) and 20 socket-head screws (10).
(5) Install two transfer gripper guards (11) and four socket-head screws (12).
(6) Install two sheet stop fingers (13), two spacers (14), and two socket-head screws (15).
(7) Check and adjust pull rail height as required.
2-262
