TM 5-3610-286-20
2-50.
Pull Rail Assembly (cont).
c. Repair. (figure 2-110)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
2-260
Remove two socket-head screws (1), two hex nuts (2), two washers (3), bar (4), and
shims (5).
Remove two socket-head screws (6), washers (7), hex nuts (8), washers (9), bar (10),
and shims (5).
Remove four socket-head screws (11) and two bars (12).
Remove pull rail holder (13), socket-head screw (14), pull rail (15), spring pin (16),
and ball bearing (17).
Remove six caged needle bearings (18) from guide piece (19).
Replace worn or grit contaminated bearings, any cracked, broken, dented, distorted, or
otherwise unserviceable items.
Assemble pull rail holder (13), pull rail (15), socket-head screw (14), spring pin (16),
and ball bearing (17).
Install six caged needle bearings (18) and rail holder (13) in guide piece (19).
Install two bars (12) and four socket-head screws (11).
Install shims (5), bar (10), two washers (9), hex nuts (8), washers (7), and socket-
head screws (6).
Install shims (5), bar (4), two washers (3), hex nut (2), and socket-head screws (1).
