TM 5-3610-286-20
2-50.
Pull Rail Assembly.
This task covers:
a. Remove
b. Repair
c. Install
d. Adjust
INITIAL SETUP
Tools
Equipment Conditions
5 mm hex key
Pull side lay assembly removed (para. 2-49)
6 mm hex key
7 mm combination wrench
a. Remove. (figure 2-109)
(1) Remove two socket-head screws (1), two spacers (2) and two sheet stop fingers (3).
(2) Remove four socket-head screws (4) and two transfer gripper guards (5).
(3) Remove 20 socket-head screws (6) and feed table (7).
(4) Remove eight socket-head screws (8) and two guide pieces (9).
NOTE
The following steps are for only one pull rail assembly.
(5) Remove socket-head screw (10), washer (11) and support (12).
(6) Remove bolt (13), compression spring (14), and shims (15).
2-258
