TM 5-3610-286-20
2-49.
Pull Side Lay Assembly (cont).
c. Inspect. Inspect pull wheels in side guides for binding, due to dirt or damage, which could
cause register problems.
d. Repair. (figure 2-106)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
(20)
2-252
Remove retaining ring (1), washer (2), and collar (3).
Remove hex-head screw (4), washer (5), and adjustment disk (6).
Slide bearing (7) off shafts (8) and (9).
Remove compression spring (10).
Remove spring tension pin (11) and set collar (12).
Loosen set screws (13) and remove two set collars (14).
Remove two stop pins (15).
Loosen tommy bar (16) and slide O/S side guide (17) off shafts (8, 9).
Remove spring tension pin (18) and slide bracket (19) off shafts (8, 9).
Loosen tommy bar (20) and slide D/S side guide (21) off shafts (8, 9).
Remove two rivets (22) and indicator plate (23).
Replace weak or broken spring (10) and unreadable or worn indicator plate (23). Replace
damaged side guides (17, 21) and clogged lubrication fitting (24).
Replace indicator plate (23) and two rivets (22).
Replace D/S side guide (21) on shafts (8, 9) and tighten tommy bar (20).
Replace bracket (19) on shafts (8, 9) and replace spring tension pin (18).
Replace O/S side guide (17) on shafts (8, 9) and tighten tommy bar (16).
Replace two stop pins (15).
Replace two set collars (14) and tighten set screws (13).
Replace collar (12) and spring tension pin (11).
Replace compression spring (10).
