TM 5-3610-286-20
2-49.
Pull Side Lay Assembly.
This task covers:
a. Service
c. Inspect
e. Install
b. Remove
d. Repair
f. Adjust
INITIAL SETUP
Tools
Tools (cont)
3 mm hex key
Stud set remover
5 mm hex key
0.050 x 0.375 x 8 in. flat-tip screwdriver
6 mm hex key
Retaining-ring pliers
8 mm combination wrench
Feeler gage
10 mm combination wrench
13 mm combination wrench
Equipment Conditions
5 mm pin punch
Ball-peen hammer
Lubrication distribution unit removed
(para. 2-78)
a.
b.
2-250
Service.
WARNING
CLEANING SOLVENT. Lithographic solvent is toxic and flammable. Wear
protective goggles and gloves and use only In a well ventilated area. Avoid
contact with skin, eyes, and clothes and don’t breathe vapors. Do not use
near open flame or excessive heat, if you become dizzy while using cleaning
solvent, get fresh air immediately and get medical aid. If contact with eyes is
made, wash your eyes with water and get medical aid immediately.
(1) Clean dirty pull wheels with solvent.
(2) Adjust pull wheels (TM 5-3610-286-10).
Remove. (figure 2-105)
NOTE
Set adjustment knobs to “O”. Measure the gap with feeler gage and record
before removing.
(1) Remove two screws (1) and pointer (2).
(2) Remove two adjustment knobs (3), knurled screw (4), socket-head screws (5), washers
(6), register feed guard (7), and V-ring (8).
