TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
c. Prepare Cylinder Assembly (Cont)
10 Remove blanket from handrail (2) and lay it over packing (3).
11 Take Printing Press off safe and inch forward while applying
light pressure to blanket until tail clamp (1) is accessible.
12 Put Printing Press on safe.
Using pin wrenches, insert tail
edge blanket bar (1) into tail clamp (2), pushing down and in, to lock
blanket bar into place.
13 Tighten tail edge worm gear of blanket cylinder. Take
Printing Press off safe and inch until lead edge is in position.
2-55
