TM 5-3610-286-10
2-7.
c.
until
OPERATING PROCEDURES (CONT)
Prepare Cylinder Assembly (Cont)
NOTE
Ensure adjustment screw heads do not bind on inner
wall of cylinder bearers.
2 Loosen locknuts (8) and turn lateral adjustment screws (9)
spaces at either end of clamp bar (7) are equal.
Tighten lock-
nuts (8).
(4) Prepare Plate and Packing
(a) Ensure plate measures 27-1/4 in. by 32-1/2 in. (69.2 by
82.6 cm).
(b) Inspect plate.
(c) Scribe register marks on plate.
1 Aline marked edge of scribe gage (1) with gripper edge of plate
and center side-to-side.
2 Draw a horizontal line at gage indentation (2) on both sides of
plate.
2-59
