TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
c. Prepare Cylinder Assembly
INITIAL SETUP
Tools
17 mm T-handle socket wrench (appendix B, section III, item 44)
13 mm T-handle socket wrench (appendix B, section III, item 44)
19 mm T-handle socket wrench (appendix B, section III, item 44)
Scribe gage (appendix B, section III, item 10)
Paper caliper micrometer (appendix B, section III, item 25)
Packing punch (appendix B, section III, item 31)
Plate wrench (appendix B, section III, item 43)
17 mm open-end wrench (appendix B, section III, item 40)
U-shaped special wrench (appendix B, section III, item 46)
Straight pin wrenches (appendix B, section III, item 42)
Packing
Materials
Blanket
Packing
gage (appendix B, section III, item 9)
(appendix D, item 4)
paper (appendix D, item 43)
No. 2 pencil (appendix D, item 48)
Light machine oil (appendix D, item 39)
Plate
Gum solution (appendix D, item 55)
Rag (appendix D, item 50)
Deglazing solution (appendix D, item 53)
Bucket (appendix B, section III, item 5)
Sponge (appendix D, item 57)
Water
General Safety Instructions
WARNING
l
EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion.
Always shout “clear” and wait for “clear” response before
taking Printing Press off safe to inch or run.
Failure to
follow this warning may result in serious Injury.
2-50
