TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
c. Prepare Cylinder Assembly (Cont)
WARNING
l
EXPOSED MOVING PARTS.
Do not inch Printing Press and wipe
cylinder at the same time.
Return Printing Press to SAFETY
STOP after each inching.
Failure to do so may result in
serious injury.
l
EXPOSED MOVING PARTS.
Remove all jewelry. Keep shirts
tucked in, sleeves above elbows, and ties removed.
Failure
to observe these precautions while operating Printing Press
may result in serious injury.
(1) Prepare Blanket Cylinder
NOTE
It is important that lead edge of blanket lines up perfectly
with shoulder of clamp. Control holes are provided for
visual inspection of blanket edge.
(a) Insert lead edge of blanket (1)
tighten eight hex head screws (3), starting
into blanket bar (2) and
from center and working out.
2-51
