TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
c. Prepare Cylinder Assembly (Cont)
(3) Parallel and Center Plate Clamps
1 Loosen tension nuts (1) until clamp bar (2) can be pushed flush
with cylinder body (3).
NOTE
Ensure adjustment screw heads do not bind on inner
wall of cylinder bearers.
2 Loosen locknuts (4) and turn lateral adjustment screws (5)
until spaces at either end of clamp bar (2) are equal.
Tighten locknuts
(4).
(c) Adjust bottom plate clamp.
1 Loosen tension nuts (6) until clamp bar (7) can be pushed flush
with cylinder body (3).
2-58
