TM 5-3610-285-14
b.
Drive out 1/8 in. (3.2 mm) retaining pin and remove main drive gear from roller H.
c.
Remove 1/16 in. (1.6 mm) pins and gears from idle end of rollers C, D, E, F, G, J, and K.
d.
Remove screws retaining rollers L and M to drive end plate.
e.
Remove studs retaining roller B to drive end plate.
NOTE
Note position and location of film guides before removing.
f.
Remove screws retaining film guides to end plates and remove film guides.
g.
Remove nuts and screws retaining tie rods to end plates.
5-207
