TM 5-3610-285-14
j.
Inspect components for damage or excessive wear. Disassemble rollers and replace any defective
components.
k.
Reinstall guide shoe assembly to idle end plate and retain with screws.
l.
Reassemble rollers and reinstall to idle end plate.
m.
Position rollers and reinstall drive end plate.
n.
Position guide shoe and retain support with screws to drive end plate.
o.
Position tie rods, square end plates, and secure with nuts and screws.
p.
Reinstall film guides in their proper position and retain with screws.
q.
Reinstall roller B retaining stud into drive end plate.
r.
Reinstall screws retaining rollers L and M to drive end plate.
s.
Reinstall gears to drive end of rollers C, D, E, F, G, J, and K. Retain with 1/16 in. (1.6 mm) pins.
t.
Reinstall main drive gear to roller H. Retain with 1/8 in. (3.2 mm) pin.
u.
Reinstall squeegee crossover assembly into unit.
5-209