TM 5-3610-285-14
i.
Remove screws from bearing retainer on right side plate. Remove retainer and bearing.
j.
Inspect components for damage or excessive wear. Replace any defective components.
k.
Install main roller bearings to side plates.
l.
Reinstall bearing retainer to right side plate.
m.
Install bearing studs in side plates and secure with nuts.
n.
Position rollers on right side plate and install left side plate.
o.
Position guide shoe support to left side plate and secure with screws and washers.
NOTE
Be sure to square end plates before securing tie rods.
p.
Reinstall nut to entrance guide tie rod and tighten. Position other tie rod and secure with nut.
q.
Reinstall key to main roller shaft.
r.
Reinstall gear to roller shaft. Secure with setscrew.
s.
Reinstall entrance crossover assembly into unit.
5-20.2 Repair Squeeqee Crossover Assembly.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Tool Kit, Light Machine Repair
Flat Tip Screwdriver
Drift Punch
Pliers
1/4 in. Drive Socket Set
SUPPLIES:
Roller
Bearing
Gear
Retaining Pin
NOTE
The following procedure is in disassembly/assembly sequence. Disassemble the squeegee crossover
assembly only as far as necessary to perform the repair.
a.
Remove squeegee crossover assembly from unit.
5-206
