TM 5-3610-285-14
5-16.31 Remove/Install Processor.
MOS:
83FJ6, Reproduction Equipment Repairer
PERSONNEL:
A minimum of three persons are required to perform this
procedure.
TOOLS:
Tool Kit, Light Machine Repair
Cross Tip Screwdriver
Flat Tip Screwdriver
1/2 in. Drive Socket Set
12 in. Adjustable Wrench
Forklift
SUPPLIES:
Plastic Utility Pail (Item 35, Appendix E)
Hose Clamps
Rags (Item 47, Appendix E)
Rubber Spray Adhesive (Item 3, Appendix E)
Safety Glasses
WARNING
Death or serious injury may occur from electrical shock unless processor circuit breaker is turned off
before servicing.
a.
Turn off circuit breaker.
b.
Remove left and right access panels from processor.
c.
Remove all rack assemblies and crossovers and store in designated area.
d.
Tag and disconnect processor electrical connections at junction box.
WARNING
Injury from chemical burns or blindness may occur if photographic chemicals splash in eyes or on
sensitive skin areas. Wear eye protection and be sure eyewash and running water are available before
working on processor.
e.
Drain chemicals and water from processor.
NOTE
Last of chemical solutions will have to be drained into pail or drip pan as lowest points will not normally
flow into drains.
5-193
