TM 5-3610-285-14
w.
Reconnect power cable.
x.
Reinstall sink (Chapter 4, paragraph 4-16.3).
y.
Reinstall plate finishing table (Chapter 3, paragraph 3-16.6).
z.
Reinstall flip-top platemaker (Chapter 2, paragraph 2-16.22).
5-17. PREPARATION FOR STORAGE OR SHIPMENT . Contact your battalion for packing and shipping instructions.
Section V. DIRECT/GENERAL SUPPORT MAINTENANCE
5-18. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND
SUPPORT EQUIPMENT.
5-18.1 Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
5-18.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. Special Tools, TMDE,
and Support Equipment is listed in the applicable repair parts and special tools list and in Appendix B of this
manual.
5-18.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List, TM 5-3610-285-
24P covering direct/general support maintenance for this equipment.
5-19. DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a.
Direct/general support troubleshooting procedures cover the most common malfunctions that may be repaired
at the direct/general support level. Repair or adjustment requiring specialized equipment is not authorized
unless such equipment is available. Troubleshooting procedures used by lower level maintenance should be
conducted in addition to the direct/general support troubleshooting procedures.
b.
This manual cannot list all the possible malfunctions or every possible test/inspection and corrective action. If
a malfunction is not listed or corrected by a listed corrective action, notify your supervisor.
c.
For unidentified malfunctions use the following schematics or the foldouts located at the end of this manual
for further fault analysis.
5-196
