TM 5-3610-285-14
k.
Place pail or drip pan under recirculating filter.
l.
Remove drain plug from recirculating filter and drain into pail.
m.
Disconnect water supply line from processor.
n.
Remove eight lag bolts mounting processor through drain pan to floor.
o.
Remove flip-top platemaker (Chapter 2, paragraph 2-16.22).
p.
Remove plate finishing table (Chapter 3, paragraph 3-16.6).
q.
Remove sink (Chapter 4, paragraph 4-16.3).
r.
Remove processor from partition and remove from the section through van's rear doors.
NOTE
If rubber insulating material around position opening has been damaged during removal of defective
processor, replace material using rubber adhesive.
s.
Install new processor into partition and secure with eight lag bolts.
t.
Reconnect all hoses to new processor. Tighten hose clamps securely.
u.
Reconnect drain and water supply lines.
v.
Reconnect exhaust hose to vent.
5-195
