TM 5-3610-285-14
h.
Remove wire ties from generator wiring. Disconnect two red generator wires from circuit board 900. Remove
defective generator and wiring.
i.
Remove three screws and adapter.
j.
While holding shaft nut with combination wrench, remove retaining screw and rotor.
k.
Install new rotor onto motor, and retain with screw.
l.
Reinstall adapter and secure with screws.
m. Install new generator assembly and retain with screws.
n.
Connect new generator wiring to circuit board 900. Apply wire ties.
o.
Reinstall generator splash guard.
p.
Reinstall front control panel and secure with screws.
q.
Reinstall TRANSPORT SPEED control knob. Tighten setscrew.
r.
Reinstall pump splash cover.
s.
Reinstall left access panel and top cover.
t.
Turn on processor circuit breaker.
5-151
