TM 5-3610-285-14
i. Press manual exposure switch and verify that exposing indicator lamp lights, and observe that light source is
visible through light security brush.
j. Press off manual exposure switch.
k. Press numerical keys on keypad to enter 10.0 units of light. Verify 10.0 appears on digital display.
1. Press "T" key on keypad to activate the exposure. Verify that digital display counts down, and that exposing
indicator lamp lights.
m. When exposure is complete, verify that exposing indicator lamp goes off and that digital display shows 10.0.
n. Press off appropriate vacuum pump switch.
o. Open appropriate vacuum bleed valve and verify vacuum is exhausted.
p. Pull out on frame release knob; flip glass frame over and lock in place.
q. Repeat steps e - o for other vacuum frame.
2-6.3 Operating Procedures.
a. Turn on power panel circuit breaker.
b. Be sure glass frame is in horizontal position and locked in place.
c. Unlock the left- and right-hand latches and lift glass frame until the two lift arms take hold and open frame
completely.
d. Verify glass is clean on both sides.
2-18
