TM 5-3610-253-14
Rotate clutch plate to the left to cover the override holes.
j.
k. Remove main power switch knob and reinstall onto control panel.
l.
Reinstall main drive gear clutch cover.
m.
Reinstall eccentric cover.
5-37. PREPARATION FOR STORAGE OR SHIPMENT.
Contact your battalion for packing and
shipping instructions.
Section X DIRECT/GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
5-38. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT
5-38.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
5-38.2 Special Tools: Test, Measurement, and Diagnostic Equipment; and Support
Equipment. Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
5-38.3 Repair Parts. Repair parts are listed and illustrated in the repair parts
and special tools list, TM 5-3610-253-24P covering direct/general support
maintenance for this equipment.
5-39. DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a. Direct/General support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level. Repair or
adjustment requiring specialized equipment is not authorized unless such equipment
is available. Troubleshooting procedures used by the operator and organizational
technician should be conducted in addition to the direct/general support trouble-
shooting procedures.
b. For unidentified malfunctions, use the facing schematic and/or the foldout
located at the end of this manual for further fault analysis.
NOTE
Sufficient data is not available for you to test or troubleshoot printed
circuit boards. When associated wiring, ribbon cables, power cords and
other related electrical components have been eliminated as possible
faults, then the printed circuit boards must be substituted, one for one,
until the fault is isolated.
