TM 5-6675-328-14
(1)
Insert collet into headstock (or tailstock) by engaging keyway of collet shank with internal key in spindle.
(2)
Engage spindle lock and screw drawbar onto collet, but do not tighten.
(3)
Insert work into collet and tighten drawbar.
(4)
Disengage spindle lock and rotate spindle through 360 degrees to be sure there is no interference from
other tooling.
NOTE
Install drill chuck in tailstock or universal three-jaw chuck in headstock in accordance with collet
instructions above.
b.
Install compound slide rest on lathe bed and tighten binding bolt.
c.
Operation.
(1)
Turn speed control knob to 0 position.
(2)
Insert power cord into 120 V ac outlet.
WARNING
Keep hands, clothing, hair, jewelry, or other loose apparel away from rotating machinery. Severe personal
injury may occur.
Eye protection must be used when operating lathe.
(3)
Set MANUAL/FOOT switch to MANUAL position.
(4)
Turn CIRCUIT BREAKER to ON position.
(5)
Set DIRECTION CONTROL switch to FWD or REV as desired.
(6)
Turn speed control knob to desired speed.
d.
Shutdown.
(1)
Set DIRECTION CONTROL switch to STOP.
(2)
Turn CIRCUIT BREAKER to the OFF position.
(3)
Remove tooling from headstock and tailstock collets.
(4)
Remove collets and install dummy collets.
5-7. OPERATION UNDER UNUSUAL CONDITIONS. This equipment is designed for operation only in a control led
environment.
5-16
