TM5-6675-326-14
6-6.2.30 Volume Erase Procedure - Continued
b .
If error is caught after initiating PRINT command,
r e p o s i t i o n p l a n i m e t e r a t s t a r t i n g p o i n t.
Press CLEAR,
, and e.
Retrace boundary of contour.
c .
If volume run is completed before error is caught, repeat
entire volume run up to error.
E l e v a t i o n a f t e r i n c o r r e ct
section does not have to be rerun.
(1) Rerun volume starting from elevation section
immediately above incorrect section down to error.
Press and d to initiate reload of volume run.
(2) Key in area of each section, read from previous
p r i n t o u t t h a t f o l l o w s i n c o r r e c t s e c t i o n . P r e ss
and
6-6.2.31 Out-of-Phase Adjustment
NOTE
Out-of-phase adjustment is used when there is
c o n s t a n t s e c t i o n i n t e r v a l , b u t s e c t i o n s a r e
not even elevations.
a .
Determine phase differential:
NOTE
Program II automatically locates next even
e l e v a t i o n f r o m f i r s t s e c t i o n e n t e r e d.
Determine what this number is, and subtract
it from desired second elevation.
R e s u lt
i s p h a s e d i f f e r e n t i a l.
Example:
Example:
Running vertical sections at 100-ft
i n t e r v a ls
Desired second elevation
Next even 100-ft elevation
P h a s e d i f f e r e n t i al
Running contours at 10-ft intervals
1215 = Desired second elevation
- 1210 = Next even 10-ft elevation
+5 = P h a s e d i f f e r e n t i a l
6-85
