TM5-6675-326-14
6-6.2.22 Measuring Lengths With Linear Measuring Probe To Be Added and/or
Subtracted - Continued
d .
e.
f .
g.
h.
i .
j .
k .
l .
m.
n.
o.
Tape drawing or map to be measured to table.
If needed, aline linear measuring probe (para 6-6.2.16).
Record RL value.
Factory determined RL
Record Sheet provided
NOTE
value is given on Calibration
with equipment.
Alinement
is performed as a check.
Key in scale of map or drawing to be measured.
P r e s s q and a to call up (from memory) lengths routine for
f e e t .
p r e s s q and d if printout in feet and inches is
desired .
NOTE
Linear measuring probe stand is used to facilitate
measurement using a straightedge.
If needed, mount linear measuring probe in stand.
Press CLEAR button to clear auto-scaler.
Press foot switch.
Do not release until ready to begin
measurement.
Position linear measuring probe so that the pricking pin is
at beginning of length to be measured.
Release foot switch.
Make measurement by tracing length of line with linear
measuring probe.
Press foot switch to Initiate Print command and freeze
count.
To make another measurement, repeat steps j through m.
If additional lengths are to be added, press q and c to
initiate ACCU and addition subroutine.
6-66
