TM5-6675-326-14
6-6.2.20 Measuring Slopes To Be Added and/or Subtracted - Continued
e.
Press foot switch to activate PRINT command and freeze
count.
NOTE
C a l c u l a t o r w i l l p r i n t h o r i z o n t a l a n d t r ue
slope surface area of shape last measured,
followed by totals (added or subtracted)
of horizontal and true slope surface areas.
f .
Keeping foot switch depressed,
reposition planimeter near
shape to be measured.
Make next measurement.
g.
If change is made in planimeter function or if new scales or
slope ratios are used,
p r e s s ~
to initiate measurement.
Begin measurement procedures.
6-6.2.21 Measuring Areas Without the Calculator
a .
Assemble QPS with the planimeter.
b.
Activate QPS:
(1) Plug foot switch into ACCU input jack on back panel of
a u t o - s c a l e r .
(2) Plug planimeter into E2 e n c o d e r s o c k e t o n b a c k p a n el
o f a u t o - s c a l e r.
(3) Plug power transformer cable
back panel of auto-scaler.
(4) Plug power transformer cable
(5) Plug power cord into back of
into POWER supply jack on
i n t o w a l l o u t l e t .
c a l c u l a t o r.
( 6 ) P l u g p o w e r c o r d i n t o w a l l o u t l e t .
(7) Set encoder OFF/E2 / E1 switch on back panel of
a u t o - s c a l e r t o E2 .
(8) Set AUDIO/OFF switch on back panel of auto-scaler to
AUDIO.
(9) Set auto-scaler B/ACCU/A/OFF switch to A.
(10) Set auto-scaler MAN/AUTO switch to MAN.
6-62
