TM 5-6675-325-14
(e) Plug power
(f) Plug power
(g) Plug power
(h) Set
(i) Set
(j) Set
(k) Set
(1) Set
(m) Set
(n) Set
(o) Set
transformer cable into wall outlet.
cord into back of calculator.
cord into wall outlet.
encoder OFF/E2/E1 switch
AUDIO/OFF switch on back
auto-scaler B/ACCU/A/OFF
on back panel of auto-scaler to E2.
panel of auto-scaler to AUDIO.
switch to A.
auto-scaler MAN/AUTO switch to MAN.
auto-scaler X MEMORY switch to 1.
calculator
calculator
calculator
OFF/ON switch to ON.
MAN/TRACE/NORM switch to NORM.
PRGM/RUN switch to RUN.
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil,
or other materials may damage magnetic cards.
(3) Load preprogrammed magnetic card (paragraph 5-6.2h), Program II, into
calculator.
(4) Tape map or drawing to be measured to table.
(5) Select correct tracer arm length.
NOTE
Tracer arm length should be shortest one possible that will allow entire
shape to be measured without moving the planimeter.
(6) If needed, aline planimeter with tracer arm length selected (paragraph
5-6.21).
5-79
