TM 5-6675-325-14
(7) Release foot switch.
(8) Press remote tracer switch to activate print command.
(10) Retrace first loop of short (smaller) side.
(11) Repeat steps (4) through (8) until last contour of short (smaller) side
has been traced and printed.
(12) Reposition tracer
(14) Trace contour.
arm to first adjacent contour on larger (higher) side.
(15) Press remote tracer switch to activate PRINT command.
(16) Repeat steps (4) through (8) until last contour of larger (higher) side
has been traced and printed.
NOTE
Calculator will print the following information after the first measurement.
l
*** Elevation
Additional measurements will provide values for area of contour, inter-
mediate volume, and total volume.
l
0.00 Area of contour
0.00 Intermediate volume
0.00 Total volume so far
through (9).
aa.
Vertical cross sections.
(1) Assemble QPS with planimeter.
(2) Activate QPS.
(a) Plug foot switch into
(b) Plug remote tracer swi
auto-scaler.
ACCU input jack on back panel of auto-scaler.
tch into PRINT input jack on back panel of
(c) Plug planimeter into E, encoder socket on back panel of auto-scaler.
(d) Plug power transformer cable into POWER jack on back of auto-scaler.
5-78
