TM 5-6675-325-14
NOTE
Calculator will print the following information after the first measurement.
***Elevation
***Section of contour loop
Additional measurements will provide values for intermediate volume and
total volume.
0.00 Intermediate volume in cubic yards
0.00 Total volume in cubic yards
(20) Move to next contour loop.
(21) Release remote tracer switch.
(22) Repeat steps (18) and (19) until desired volume is determined.
(23) TO change contour interval when next loop to be measured is at a
different interval, key in new interval.
(24) If last elevation is not even contour interval, key in
elevation.
Repeat steps (18) through (23).
steps (12) through (18).
y.
Merging volume runs.
(1) Assemble QPS with planimeter.
(2) Activate QPS.
value for last
memory. Repeat
(a) Plug
(b) Plug
auto-scaler.
(c) Plug
(d) Plug
auto-scaler.
(e) Plug
(f) Plug
(9) Plug
foot switch into ACCU input jack on back panel of auto-scaler.
remote tracer switch into PRINT input jack on back panel of
planimeter into E1 encoder socket on back
power transformer cable into POWER supply
transformer power cable into wall outlet.
power cord into back of calculator.
power cord into wall outlet.
panel of auto-scaler.
jack on back panel of
(h) Set encoder 0FF/E2/E1 switch on back panel of auto-scaler to El.
(i) Set AUDIO/OFF switch on back panel of auto-sealer to AUDIO.
5-73
