TM 5-6675-325-14
Table 3-4. DIRECT/GENERAL SUPPORT TROUBLESHOOTING - Cont
M A L F U N C T I O N
TEST OR INSPECTION
CORRECTIVE ACTION
1. LONG WARM-LIP CYCLE - Cont
(d) Normal resistance for one-half of heater circuit is 40 ohms. If either half
of heater circuit is high (greater than 50 ohms), one ore more of heaters
in that half of heater circuit is open.
(1) If resistance is correct, proceed to step 2.
(2) If resistance is incorrect, replace heater ropes (paragraph 3-20.5).
Step 2. Check thermal roller temperature.
Adjust temperature if incorrect (paragraph 3-20.2).
2. PAPER ERROR LIGHT COMES ON DURING PRINT CYCLE.
Step 1. Adjust potentiometers.
(a) Unplug power cord and remove rear panel of reader-printer.
(b) Open logic board protective cover.
Change 1
3-93
