TM 5-6675-325-14
Table 3-4. DIRECT/GENERAL SUPPORT TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. PAPER ERROR LIGHT COMES ON DURING PRINT CYCLE - Cont
(c) Set multimeter to read 0-5 V dc.
(d) Attach positive lead to TP5 on logic board.
(e) Attach negative lead to top end of capacitor C3.
CAUTION
Between dc return of logic and chassis of reader-printer, 105 V ac exists. Never use chassis as common when
making dc measurements on logic board. Erroneous readings will result and damage equipment.
(f)
(g)
(h)
(i)
(j)
(k)
(1)
(m)
Plug in power cord.
Switch reader-printer ON.
Place print length switch into LONG PRINT position.
Rotate long print potentiometer RI 00 to obtain maximum voltage
reading. This must be +3.75 V dc or greater.
Adjust R100 to read +2.50 to +2.75 V dc.
Place print length switch into SHORT PRINT position.
Rotate short print potentiometer RI 01 to obtain maximium voltage
reading. This must be +3.75 V dc or greater.
Adjust R101 to read +2.50 to +2.75 V dc.
If either long or short print potentiometers cannot be adjusted to produce minimum of
+3.75 V dc, replace appropriate sensor.
Step 2. Check temperature of thermal roller.
(a) If temperature is correct, proceed to step 3.
(b) Adjust if necessary (paragraph 3-20.2).
3 - 94
Change 1