TM 5-6675-325-14
NOTE
Mark position of sensor on paper guide with yellow grease pencil before
removal.
Be sure sensor is parallel to paper guide.
d. Mark position of sensor on paper guide rail. Then remove screw.
e.
Disconnect sensor leads and remove sensor.
f. Fit new sensor between guide rails. Reconnect sensor leads.
g.
Aline new sensor with grease pencil mark parallel to paper guide rail.
h. Be sure that paper guide rail is against paper.
i.
Reinstall and tighten screw.
j.
Reinstall rear paper loading door.
3-16.6 Replace Transformer Assembly.
MOS: 35E, Special Electronic
TOOLS: Cross Tip Screwdriver
Devices Repairer
3/4 in. combination Wrench
7/16 in. Combination Wrench
9/16 in. Combination Wrench
3/8 in. Combination Wrench
Screw Starter
SUPPLIES:
Transformer Assembly
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a.
Unplug power cord.
3-68
