s .
t .
u.
v.
w.
x.
TM 5-6675-325-14
Place lower microfiche glass back edge into rear of microfiche
handler with front edge tilted up. Push in and, at same time, lower
front edge.
Place rear edge of upper microfiche glass into rear of holder with
front edge tilted up. Lower front edge.
Close left and right panels.
Push microfiche handler into reader-printer, observing that upper
microfiche glass closes as handler moves in.
Reinstall reader-printer on stand and secure with mounting hardware.
Plug in power cord.
3-16.4 Adjust Optical Sensors.
MOS: 41B, Topographic Instrument Repair Specialist
TOOLS: Offset Cross Tip Screwdriver
a.
b.
c.
d.
e.
f.
9*
h.
i.
j.
Rule (12 in.) .
Plug power cord into outlet.
Allow reader-printer to complete warm-up cycle.
Place print length switch in SHORT PRINT position.
Push PRINT switch.
Measure resultant paper length and note measurement.
Place print length switch in LONG PRINT position.
Push PRINT switch.
Measure resultant paper length and note measurement.
Remove power cord from outlet.
Compare print length measurements with specification (Table 3-4).
3-65
