TM 5-6675-325-14
Table 3-3. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. PRINT SWITCH DOES NOT ACTIVATE PRINT.
Step 1.
Test for defective print length switch as follows:
(a) Select SHORT PRINT on print length switch.
(b) Press PRINT switch.
(c) If print is not produced, select LONG PRINT on print length
switch.
(d) Press PRINT switch.
(e) If PRINT is produced in only
switch, replace print length
one position of print length
switch (paragraph 3-16.3).
(f) If reader-printer will not print in either switch position,
proceed to step 2.
Step 2.
Test alinement of optical sensors on printing easel.
(a) If in proper alinement, proceed to step 3.
(b) Adjust optical sensors (paragraph 3-16.4).
Step 3.
Test optical sensors for blocked or faulty operation.
(a) If optical sensors operate properly, proceed to step 4.
(b) Replace optical sensors (paragraph 3-16.5).
Step 4.
Test PRINT switch for continuity.
(a) If continuity does not exist replace PRINT switch (paragraph
3-16.3).
(b) If continuity exists, refer to direct/general support
maintenance.
3-49
