TM 5-6675-324-14
Section V
DIRECT/GENERAL SUPPORT MAINTENANCE
5-18. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE) ; AND SUPPORT EQUIPMENT.
5-18.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
5-18.2 Special Tools; Test. Measurement, and Diagnostic Equipment; and Support
Equipment. Special tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
5-18.3 Repair Parts.Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-324-24P covering direct/general support
maintenance for this equipment.
DIRECT/GENERAL SUPPORT TROUBLESHOOTING.
There are no direct/general support troubleshooting procedures assigned for this
equipment.
a. This section contains instructions covering direct/general support
maintenance functions for the quantity processing system. Personnel required are
listed only if the task requires more than one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
INDEX
PARAGRAPH
PROCEDURE
Replace Planimeter Encoder . . . . . . . . . . . . . . . . . . . . . . .
Aline Planimeter Encoder . . . . . . . . . . . . . . . . . . . . . . . .
Replace Main Logic PC Board .
....................
q
Replace Front Display PC Board . . . . . . . . . . . . . . . . . . . . .
Replace Rear Input PC Board . . . . . . . . . . . . . . . . . . . . . .
Replace Scaler PC Board . . . . . . . . . . . . . . . . . . . . . . . .
